USNR's Coe veneer lathe charger, pressure bar and core drivers are integral to the complete veneer lathe system.

Lathe Charger
- Dual lathe charger spindles process blocks from 4" to 30" in diameter
- BlockPLUS™ optimization system scans while the block rotates and positions
- Faster spindle rotation and positioning allows cycle speeds up to 18 blocks per minute
- Precise charger pendulum control for faster "wood to wood" time
- Heavy duty construction throughout with advanced electronics and controls

Pressure Bar
- Evenly applied torque reduces the force of the spindles on the ends of the block
- Force is imparted along the length of the block rather than at the lathe chucks
- Large diameter powered roll virtually eliminates slivers
- Fluted alloy steel roller is supported in precision bearing blocks with replaceable liners
- Servo-controlled vertical bar height adjustment applies maximum continuous block contact
- Available with offset roll-drive arrangement